Please refer to the following alarm codes pertain to the FANUC 200VAC and 400VAC PS modules with codes PSM HV, PSM, and PSM-R (part numbers started from A06B-6077, A06B-6081, A06B-6087, A06B-6091). Knowing your error code could help us provide you with the fast and precise evaluation for FANUC power supply repair or exchange services.

Request a Free Consultation

Please contact us for free consultation about any of the following error codes, or any other problems with your FANUC power supply. Call 630-616-0039 or fill up a contact form.

Alarm Code	Description of Alarm/Error
1	Overcurrent flowed into the input of the main circuit.
2	A cooling fan for the control circuit has stopped.
3	The temperature of the main circuit heat sink has risen abnormally.
4	In the main circuit the DC voltage (DC link) has dropped.
5	The main circuit capacitor was not charged with the specific time.
6	The control power supply voltage decreases.
7	In the main circuit the DC voltage at the DC link is abnormally high.
8	There is excessive short-term regenerative power
A	A cooling fan of external cooling has stopped.
E	The input power supply is abnormal (open phase)
H	The temperature of the regenerative resistor has risen abnormally.

PSM-5.5i, PSM-11i, PSM-15i, PSM-26i, PSM-30i, and PSM-37i Alarm / Error Codes

Alarm Code	Description of Alarm/Error
1 ( For PSM-5.5i to 15i)	The main circuit power module (IPM) has dedected an abnormal condition.
1 ( For PSM-5.5i to 37i)	Over current flowed into the input of the main circuit.
2	A cooling fan for the control circuit has stopped.
3	The temperature of the main circuit heat sink has risen abnormally.
4	In the main circuit the DC voltage (DC link) has dropped.
5	a. The input power supply is abnormal. b. The main circuit capacitor was not recharged within the specified time.
6	The control power supply voltage decreases.
7	In the main circuit the DC voltage at the DC link is abnormally high.
A	A cooling fan of external cooling has stopped.
E	The input power supply is abnormal (open phase)

Request a Free Consultation

Please contact us for free consultation about any of the following error codes, or any other problems with your FANUC power supply. Call 630-616-0039 or fill up a contact form.